Sika Pyroplast Intumescant Top W (MATT White )

Sika Pyroplast Top W forms a carbon char when affected by heat as it uses a water based fire protection coating intended for internal use. This is a 2 pack coating you will require Sika Wood P Base Coat . See Product Here. Sika Pyroplast system slows the spread of flame on natural wood & wood by-products.Sika Pyroplast contributes a beautiful option to architects, builders and end-users, all while accentuating the interior composition of timber arrangements.USESLessens the combustibility of hard- and softwood > 10 mm thickness and other timber by-products, such as plywood, chipboard, fibre insulation board, hardboard and also on veneering > 12 mm thickness.Shields against heat, checks fire, restricts the generation of fire and spread of flame and reduces flue-gas temperatures.Sika Pyroplast system should not be used in areas of high humidity, heat sources or on surfaces where significant physical impact is likely.PROPERTIESWater based coating systemVOC Sika Pyroplast Wood P: 0 g/lVOC Silka Pyroplast Top W: approx. 48 g/lFree of Halogens and aromatic solventsLow material consumptionSimple applicationNo additional statical load of coatingIndividual coloration possible with topcoat Silka Pyroplast Top WTESTSApproval/StandardsSilka Pyroplast Wood P is classified to many standards worldwide including EN 13501-1, Bs1d0.PRODUCT DATAColour Shades:Sika Pyroplast Wood P Primer: whiteSika Pyroplast Wood P: white, black on inquirySika Pyroplast Top W: available in all RAL colours, others available on requestPackaging:Sika Pyroplast Wood P Primer: 5 kg, net weightSika Pyroplast Wood P: 5 kg and 25 kg, net weightSika Pyroplast Top W: 3 l and 11 kg, net weightImdg-Code-No Not applicableSHELF LIFE 18 months, in cool and dry storage conditions and original unopened containers.Protect against frost!SYSTEMSCoating Systems: Primer (if necessary), Sika Pyroplast Wood P PrimerIntumescent coating, Sika Pyroplast Wood PTopcoat, Sika Pyroplast Top WSurface Preparation:Substrate must be dry, free from dust, oil, wax, grease, dirt, resin, etc; Existing coatings with poor adhesion have to be completely removed, e.g. with solvent-based paint stripper or to be rubbed down. Surfaces that have been treated with non-acid resistant coatings or release agents such as emulsion paints containing lime, chalk or lithopone should be rubbed down completely. Timber substrates with wetting difficulties should be roughened thoroughly with abrasive paper.Pre-Treatment with Wood Preservatives:If resistance to wet rot, fungi or insect attack is requested, we recommend using commercial preservative agents based on oil alkyd resins provided they are compatible with the Sika Pyroplast fire protection system. Apply Sika Pyroplast fire protection coating system only after the preservative treatment is completely dry. The moisture content of the timber should be below 15%. Sika Pyroplast Wood P Primer may be used to allow sufficient adhesion or avoid diffusion of wood ingredients on resinous wood.