Electrolytic Scale Inhibitor

Go Geothermal Ltd October 2016 Newsletter 65% of the UK population is provided with hard water, which contains high levels of calcium and magnesium salts. This limescale builds up inside household appliances, causing them to run less effectively and increasing the likelihood of premature breakdown. By protecting against the build-up of limescale, it could also save up to £130 a year on typical energy bills, as scale also impairs the efficiency of heat transfer. Stocked by Go Geothermal the SESI is an electrolytic scale inhibitor, a cost-effective solution to help tackle limescale build up. It provides a long term solution which requires no maintenance and protects the whole house without introducing any undesirable chemicals to the drinking water. Key features • Protects against limescale encrustation • WRAS approved • 5 year guarantee • Available in 22mm from Stock • Recommended by the Compliance Guide to Part L1 of the Building Regulations • Takes just a few minutes to install The unit should be installed in the rising main of the municipal water supply, but after the water meter and primary filter units (if fitted), so that the whole property is protected. If the device is fitted to protect only a single appliance (i.e. the DHW), there should be at least 3 metres of water pipe between the SESI unit and the appliance. The unit must be installed in accordance with WRAS installation requirements. As used by one of our directors "We couldn't install the SESI onto the main water feed into my house, so we had one put on the flow into the DHW. The reduction in scale deposits in the shower was absolutely incredible. Why wouldn't you install one?" - Sean Sowden Further Efficiency Measures For more efficiency increasing measures concerning your customer's heating system, please see below: Magnetic System Filters Many untreated or improperly treated heating systems suffer from an accumulation of debris, collectively referred to as sludge deposits. Made up of corrosion products, water hardness flakes and installation or maintenance debris, this sludge can cause premature equipment failure or block/restrict system flow – directly reducing system life, efficiency and effectiveness. The SpiroTrap MB3 is an extremely effective and powerful dirt separator for removing both magnetic and non-magnetic dirt particles from central heating systems. • Detachable powerful magnet • Rotating connector to enabling the unit to be installed on horizontal, vertical and even diagonal pipes • 20 Year Guarantee Servicing takes just 30 seconds (emptying of deposits). The removal of parts is NOT required. Air Eliminators Air – in other words Oxygen – once present in a heating system, can cause blocks in radiators and pipe work due to the forming of large air pockets. The presence of oxygen can also cause corrosion of system components The SpiroVent RV2 automatically deaerates the system water and vents air as it circulates the heating system, leaving the system totally air free. • Removes circulating air and micro bubbles effectively. • Rotating connector to enabling the unit to be installed on horizontal, vertical and even diagonal pipes • 20 Year Guarantee Sentinel X100 Formulated as a multipurpose treatment to inhibit corrosion, scale, boiler noise and hydrogen gassing in all types of indirect heating systems including those containing aluminium components. Sentinel X100 is suitable for use in all waters, both hard and soft. The formulation is completely non-toxic. 1 litre of Sentinel X100 is sufficient to treat a typical domestic system of up to 10 radiators. Features and Benefits: • Effectively controls scale and corrosion • Complex pH stabilisation pack • Helps prevent the formation of hydrogen gas • Suitable for all metals including aluminium • Easy to handle - Non-toxic and biodegradable • Concentration is easily checked with a Sentinel Test Kit or a conductivity meter • Supplied in 1L, 10L and 20 litre tubs