Trend LOCK/JIG Lock Jig

Product Code: TRE-LOCK-JIG

Trend LOCK/JIG Lock Jig

This new jig uses a set of interchangeable templates and with a router will cut the mortice and face-plate recess for popular door locks.

The jig requires a router fitted with a 30mm guide bush and 12mm diameter long reach cutter.

For most common sash mortice and dead locks, with up to 2 1/2" deep mortises and a 7/8" or 1" face-plate.

Deeper mortises can be achieved with a suitable size of auger bit.

Also suits face-plate on a 1" mortice latch.

Fast, clean and accurate results, even in hardwood and doors with knots.

Can be used with locks having the following Face-plate dimensions:
Imperial...................Metric...............Template
7/8" x 6 1/8"........22.2 x 156mm.............1
7/8" x 6"...............22.5 x 152.5mm.........2
1" x 4 3/4"...........25.4 x 121mm.............3
1" x 5"..................25.4 x 127.5mm.........4
1" x 5 1/4"...........25.4 x 133.5mm..........5
1" x 5 3/4"...........25.4 x 145mm.............6
1" x 6".................25.4 x 153mm.............7
1" x 6 1/8"..........25.4 x 156mm..............8
1" x 6 1/2"..........25.4 x 165.5mm...........9
1" x 7".................25.4 x 177mm...........10
1" x 2 1/4"..........25 x 57.5mm..............11 UPPER
1" x 2 1/4"..........25.6 x 56.5mm...........11 LOWER
1" x 6 3/8"..........25.6 x 162mm............12


Mortise dimensions:
These are maximum mortise lengths, unless radius ends are squared with a Corner Chisel. However smaller mortise locks can be accommodated depending on position of their fixing screws.

Imperial..............Metric..........Template
5/8" x 2 7/8".....16 x 72mm...........A
5/8" x 4 1/4".....16 x 107mm.........B
3/4" x 3 1/8".....19 x 78mm...........C
3/4" x 4 1/4".....19 x 109mm.........D

+ These are maximum mortise lengths, unless radius ends are squared with a chisel. However, smaller mortise locks can be accommodated depending on the position of their fixing screws.

Use with Trend router bits:-
TRE-TR12X1/4TC Two Flute Straight Cutter, 1/4" Shank, 12.0mm Diameter, 19.0mm Cut
TRE-TR37X1\2TC Two Flute Straight Cutter, 1/2" Shank, 12.0mm Diameter, 54.0mm Cut