Manufacturers Of Push-Loc D4003 Coupler
Looking for more about Manufacturers Of Push-Loc D4003 Coupler?Part size - 25mm MDPE TO 22MM Stop End
Description
PUSH-LOC
Part size (listed below)
MDPE coupling to female brassware
For use ABOVE OR BELOW GROUND
Can be used with hot or cold water
PUSH-LOC advantages
True push fit, no wrenches required
Reduces labour time
Rated at 30bar pressure
Pull and snatch tested to over 200kg
No flow restriction
No liner required
Our original PUSH-LOC was developed to solve the problem of Joining MDPE to copper. The MDPE end is FOR 20 to 25mm. The copper compression end is for use with 15 to 25mm copper and exceeds current water regulations
for use on hot and cold water up to 80c. PUSH-LOC will withstand end loads up to 200kg and is pressure tested to 30bar and can withstand temperatures ranging from -35c to 250c. D4003 PUSH-LOC 25mm push-fit fitting
Stop End for use with MDPE. D4004 PUSH-LOC is a 25mm push-fit fitting to solve the problem of Joining MDPE to MDPE. We use dual O ring technology as a positive pipe stop that allows for any MDPE manufacturing tolerance and
supports side loading. We then use a specially designed grip ring that allows a true PUSH-FIT, grips MDPE without any pipe distortion or restricted flow. For help with ascertaining the correct PUSH-LOC you require please
visit our recourses link to find our installation pipe chart.
Please contact us for further information about Manufacturers Of Push-Loc D4003 Coupler.
Rated at 30bar pressure
Pull and snatch tested to over 200kg
No flow restriction
No liner required
Our original PUSH-LOC was developed to solve the problem of Joining MDPE to copper. The MDPE end is FOR 20 to 25mm. The copper compression end is for use with 15 to 25mm copper and exceeds current water regulations
for use on hot and cold water up to 80c. PUSH-LOC will withstand end loads up to 200kg and is pressure tested to 30bar and can withstand temperatures ranging from -35c to 250c. D4003 PUSH-LOC 25mm push-fit fitting
Stop End for use with MDPE. D4004 PUSH-LOC is a 25mm push-fit fitting to solve the problem of Joining MDPE to MDPE. We use dual O ring technology as a positive pipe stop that allows for any MDPE manufacturing tolerance and
supports side loading. We then use a specially designed grip ring that allows a true PUSH-FIT, grips MDPE without any pipe distortion or restricted flow. For help with ascertaining the correct PUSH-LOC you require please
visit our recourses link to find our installation pipe chart.
Please contact us for further information about Manufacturers Of Push-Loc D4003 Coupler.
Visit the Melimatic Ltd website for more information on Manufacturers Of Push-Loc D4003 Coupler
ENQUIRY FORM
