Lithofin MN Colour Intensifier W (Water Based Sealer) - 5 Litre

Product Code: 31103

Preliminary Remark: Water based protective treatments have different chemical properties than their solvent based counterparts. These differences must be taken into consideration when applying these products.\nDescription:\nThis ready-to-use protective treatment is water based and free of solvents.\nIt contains special colour intensifying components, which are in part based on natural and renewable raw materials. This product does not produce any unpleasant or harmful fumes.\nProperties:Lithofin MN Colour Intensifier >W< penetrates into absorbent stone surfaces and cures inside the pores.\nSurfaces look darker almost like they are wet, but without any gloss.The water repellent effect protects against water borne staining and facilitates regular maintenance.Lithofin MN Colour Intensifier >W< does not form a film on the surface, therefore the water permeability of the stoneremains largely intact. The slip resistance is hardly affected.\nField of Use:For treating wall and floor surfaces, stairs, entrance ways, terraces etc. that appear too light and colourless or need to?be matched to the colour of polished materials.Suitable for indoor and outdoor use.\nSurfaces: All absorbent, porous natural stones with rough, sawn, honed (max. C120), flamed surfaces, for examplegranite, gneiss, porphyry, marble, limestone, slate as well as for concrete slabs with rough surfaces.#Please Note: for polished or finely honed natural and concrete stone, we recommend Lithofin STAINSTOP >WECO< or Lithofin MN Stain-Stop.\nDirections for Use:Check the suitability and effect by testing in an inconspicuous area or on a spare tile.The surface must be absorbent, completely dried out, clean and free of stains.\nApplication Tools: (wide) brush, roller.Application: Shake bottle before use. Do not dilute product.Apply Lithofin MN Colour Intensifier >W< evenly and generously, working cross-wise. On very absorbent surface apply a second coat immediately.Do not allow streaks, puddles and similar residues to dry on the surface.If too much product has been applied on stone with a low absorbency, the product may produce a shiny film.\nThis film can be removed with Lithofin MN Power-Clean undiluted.Please Note: The surface to be treated must be completely dried out (on newly installed surfaces up to 8 weeks, afterrain or cleaning several days).\nNon-absorbent surfaces for example fired materials such as clinker, porcelain tiles or resinated natural stone, fresh concrete cannot be treated.